Eclipse CD1200 Owner's Manual page 46

Cd/usb multi-source receiver
Hide thumbs Also See for CD1200:
Table of Contents

Advertisement

Other information
Mode
Problem
Dead or weak
sound
Power does not
turn on.
Common
Frequencies or
to all
titles set in
memory are
deleted.
No guide tone
sounds.
The remote
control does not
work.
46
Causes
Is the volume control up sufficiently?
Is the muting function in effect (MUTE)?
Is the fader or balance control set far to one
side?
Other probable causes include broken
audio-signal wiring or a faulty speaker.
Are there too electrical items installed,
causing a lack of power?
Other probable causes include a run-down
car battery, broken power or
interconnection wiring.
Has the car battery been disconnected for
repair or checked out?
Are there too electrical items installed and
causing lack of available power?
Other probable causes include run-down
car battery, broken power or
interconnection wiring.
Is the guide tone disabled?
Is the main unit connected to an external
amplifier?
Is the battery low?
Is the battery installed in reverse polarity?
Is direct sunlight hitting the remote control
light receptor?
Other probable causes include a
malfunctioning remote control.
Remedial action to take
Turn up the volume control.
Cancel the muting (MUTE)
function.
Readjust the fader and
balance controls to more
normal positions.
Have your dealer check the
problem.
Have your dealer check the
problem.
Have your dealer check the
problem.
Reenter them into memory.
Have your dealer check the
problem.
Have your dealer check the
problem.
Enable the guide tone.
When an external amplifier is
connected, the guide tone will
not sound.
Replace battery.
Reinstall the battery in the
correct polarity.
Use the remote control close
to the receptor.
Have your dealer check the
problem.
Refer
to
page
14
14
36
32
38
38
35
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents