Changing The Reception Sensitivity; Changing The Radio Band Location - Eclipse CD1200 Owner's Manual

Changing the reception
sensitivity
The main unit lets you select the reception
sensitivity. The two sensitivity modes available
for this main unit are LOCAL mode and DX
mode.
The reception sensitivity is set to the
LOCAL
low level so that stations with strong
Mode
signals are received.
Because the reception sensitivity for
automatic scanning is set to the high
level from the start, even stations
DX Mode
with weaker signals can be received.
(Signal crossover may result in
some stations being hard to hear.)
1 1
Press the [FUNCTION] button.
The Menu Selection mode is activated.
Press the [SELECT] button
repeatedly, until DX/LOCAL mode
2 2
is selected.
3 Turn the [VOL] button.
The mode will switch between
LOCAL mode and DX mode each
time the button is turned.
The selected settings will take effect.
How to operate the tuner

Changing the radio band location

The location for the radio bands used between
the North American region and the Asia/
Australia/South American (Latin) region can be
switched. The default setting is USA (North
America).
Check that the main unit is in
1 1
standby mode.
Press and hold button [6], then the
2 2
[BAND/ASM] button, and hold both
for more than two seconds.
The radio band switches in the order
shown below each time the buttons
are pressed.
USA → LATIN → ASIA → AUS →
USA
When the power is turned on, the
broadcast stations will be searched for
automatically and stored in buttons [1]
to [6].
VI
33