Remove The Microsd Card; Charge The Battery - Nokia 6300 - Cell Phone 7.8 MB User Manual

1. Remove the back cover of the device.
2. Insert the card into the microSD card slot with the contact
surface facing down, and press it until it locks into place.
3. Close the back cover of the device.

Remove the microSD card

Important: Do not remove the memory card in the middle of an operation when
the card is being accessed. Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on the card may be corrupted.
You can remove or replace the microSD card during phone operation without switching
the device off.
1. Make sure that no application is currently accessing the microSD memory card.
2. Remove the back cover of the device.
3. Press the microSD card slightly in to release the lock.
4. Remove the microSD card from the slot.

Charge the battery

Check the model number of any charger before use with this device. This device is
intended for use when supplied with power from the AC-3 or AC-4 charger.
Warning: Use only batteries, chargers, and enhancements approved by Nokia
for use with this particular model. The use of any other types may invalidate any
approval or warranty, and may be dangerous.
For availability of approved enhancements, please check with your dealer. When you
disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.
1. Connect the charger to a wall socket.
2. Connect the lead from the charger to the socket on the
bottom of your device.
If the battery is completely discharged, it may take a few
minutes before the charging indicator appears on the display
or before any calls can be made.
The charging time depends on the charger used. Charging a
BL-4C battery with the AC-3 charger takes approximately 2 hours and 45 minutes while
the device is in the standby mode.
* Be aware that the battery talk and standby times information is subject to change.
For more information, contact your service provider.
Get started
11