10
Get started
3
Insert the card into the microSD card
slot with the contact surface facing
down, and press it until it locks into
place.
4
Replace the battery.
5
Replace the back cover.
Remove the microSD card
1
Remove the back cover of the device.
2
Remove the battery.
3
Press the microSD card slightly to
release the lock, and pull the card out.
Charge the battery
Your battery has been precharged, but the
charging levels may vary.
1
Connect the charger to a wall outlet.
2
Connect the charger to the device.
3
When the battery is fully charged,
disconnect the charger from the
device, then from the wall outlet.
You also may charge the battery with a
USB cable with power from a computer.
1
Connect the USB cable to the USB port
of a computer and to your device.
2
When the battery is fully charged,
disconnect the USB cable.
If the battery is completely discharged, it
may take several minutes before the
charging indicator appears on the display
or before any calls can be made.
The charging time depends on the charger
used. Charging a BL-6Q battery with the
AC-8 charger takes approximately 1 hour
25 minutes while the phone is in the home
screen mode.
Antenna
Your device may have internal and
external antennas. As with any radio
transmitting device, avoid touching the
antenna area unnecessarily while the
antenna is transmitting or receiving.
Contact with such an antenna affects the
communication quality and may cause the
device to operate at a higher power level
than otherwise needed and may reduce
the battery life.
The figure shows the antenna area
marked in grey.
Strap
1
Remove the back cover.
2
Attach a strap, and tighten it.