Sony HVL-F60M Operating Instructions Manual page 83

Notes on wireless flash
• You cannot use a flash meter or color meter in wireless flash mode because the
pre-flash goes off.
• Test flash for the wireless flash is in the currently selected test flash mode. One
flash occurs with [1 TIME] and three flashes with [3 TIMES]. Flashes continue
for four seconds with [4 SEC]. For details of test flash, see "MENU settings"
(page 88).
• The zoom position for the HVL-F60M is automatically set to 24 mm. A zoom
position other than 24 mm is not recommended.
• In wireless flash mode, ADI metering is canceled and P-TTL flash metering is
used automatically (page 35).
• Multiple flash cannot be used.
• If another wireless flash is being used nearby, you can change the channel in the
MENU settings to prevent interference (page 88).
• When photographing with the wireless flash, the flash unit may in rare cases go
off by mistake due to ambient static electricity or electromagnetic noise.
When not in use, press the MODE button and select [
(flash off).
• The flash unit may in rare cases provide incorrect luminescence because the
signal light does not reach the subject, etc,. due to the position in which the
wireless flash was installed. In this case you can prevent incorrect luminescence
by changing the installation position of the wireless flash or changing the
wireless channel setting in the MENU settings (page 88).
• You can use several off-camera flashes at the same time.
• The off-camera flash fires with the power level set in each flash when the
off-camera flash is in the manual mode.
] to set mode
83
GB