Sony HVL-F60M Operating Instructions Manual page 82

2
Attach the controller to the camera, and turn on the
power of the camera, controller, and off-camera flash.
3
Set up the camera with the controller and the
off-camera flash.
• See page 64 for details.
4
Make sure that the controller and the flash unit are fully
charged.
• When the flash unit is fully charged in the wireless flash mode, the AF
illuminator on the front blinks, and the TEST button is lit in amber.
5
Use test-flash to check the flash.
• The test-flash method differs depending on the camera used. For details,
refer the operating instructions of your camera.
• If the test-flash does not work, change the position of the camera, flash and
subject, or point the wireless control-signal receiver towards the camera.
Moreover, make sure that the wireless channel of the off-camera flash is set
to the same channel as the controller.
6
Check again that the controller and the flash unit are
fully charged, and press the shutter button to take the
photo.
82
GB