Aluminum Foil And Oven Liners; Changing Oven Light - Electrolux EI30GF35JS Use And Care Manual

42
Care and Cleaning

Aluminum foil and oven liners

Do not use oven bottom liners or use aluminum
foil to cover the oven racks.
CAUTION
Protective liners—Do not use aluminum foil to
line the oven bottom, except as suggested in the
manual. Improper installation of these liners may
result in a risk of electrical shock, or fire.
Using a liner in
the oven
restricts the
heat and air
flow needed to
obtain the best
possible
cooking results
for any oven.
During self-clean the oven temperature can
become hot enough to melt aluminum cooking
utensils or aluminum foil if left in the oven. This
could result in permanent damage to the oven
interior and porcelain finish.
Changing the oven light
CAUTION
Be sure the range is unplugged and all parts are
COOL before replacing oven light. Wear a
leather glove for protection against possible
broken glass or burns.
The oven lights are located at the rear of the oven
cavity and are covered with a glass shield held by a
wire holder (Figure 1). The glass shield protects the
light bulb and must be in place whenever the oven
is in use.
glass
shield
wire
holder
Fig. 1
To replace interior oven light bulb:
1. Turn electrical power off at the main source or
unplug the range.
2. Press wire holder to one side to release the
glass shield that covers the light bulb.
3. Replace light with a new 40 watt appliance
bulb.
4. Replace glass shield over bulb and snap wire
holder back into place.
5. Turn power on at main source (or plug the
appliance in).
6. The clock will then need to be reset. To reset,
see Setting clock in this Use & Care Guide.