Connect Drain Hose; Connect The Inlet Hoses - Maytag MVWB800VB - 28" Washer With SuperSize Capacity Plus Use And Care Manual

Proper connection of the drain hose protects your floors from damage due to water leakage.
Read and follow these instructions.
The drain hose is connected to your washer and is stored inside the washer cabinet.
Remove drain hose from washer cabinet
Pull the corrugated drain hose out of the washer by first grabbing the pull tie. Continue to
pull the hose until the end emerges. Do not force excess drain hose back into the rear of
the washer.
8

Connect Drain Hose

Laundry tub drain or standpipe drain
Connecting the drain hose form to the corrugated drain hose
1. Feed end of drain hose into one end of form. Place end of drain hose
form into the drain hose relief.
2. Bend the hose over the top of the form and feed into the other end of
the form. Attach the other end of the form into the drain hose relief.
The hose must extend 4
To keep drain water from going back into the washer:
Do not force excess drain hose into standpipe. Hose should be secure but loose enough
■
to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
■
floor drain
Do not install the drain hose form onto the corrugated drain hose. You may need additional
parts. See Floor drain under "Tools and Parts."
1. Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers
in the couplings.
A
A. Drain hose reliefs
⁄ " (11.4 cm) beyond the form.
1
2

Connect the Inlet Hoses

A B
A. Coupling
B. Washer
4.5"
(11.4 cm)