Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 40

3
Mapping FC targets to iSCSI VTs
Mapping LUNs on a specific port to an iSCSI VT
The iscsiCfg
VT.
To map LUNs on a specific port to an iSCSI VT
1. Connect to the switch and log in.
2. Enter the iscsiCfg
The following example maps two LUNs attached to port 2f:ff:00:06:2b:0d:12:99 to an iSCSI VT
named iqn.2006-10.com.example:disk001:
26
The following is an example.
switch:admin> iscsicfg --show lun -t iqn.2006-10.com.example:disk001
Number of targets found: 1
Target: iqn.2006-10.com.example:disk001
Number of LUN Maps: 1
FC WWN
21:00:00:04:cf:e7:73:7e
add lun command can be used to map LUNs attached to a specific port to an iSCSI
--
add lun command with –t <IQN>, –w <port WWN>, and –l <n:n> options
--
to add an LUNs attached to a specific port device to an iSCSI VT:
where:
-t Specifies the unique IQN name for the iSCSI VT in the format:
iqn.2002-12.com.brocade:<user_defined_name>.
-w Specifies the port WWN of the physical FC target
-l Maps the physical FC LUNs to virtual iSCSI LUNs and is specified as a pair:
LUNs:physical LUNs
switch:admin> iscsicfg --add lun -t iqn.2006-10.com.example:disk001 \
-w 2f:ff:00:06:2b:0d:12:99 -l 1-2:0-1
The operation completed successfully.
switch:admin> iscsicfg --show lun -t iqn.2006-10.com.example:disk001
Number of targets found: 1
Target: iqn.2006-10.com.example:disk001
Number of LUN Maps: 2
FC WWN
21:00:00:04:cf:e7:73:7e
2f:ff:00:06:2b:0d:12:99
Virtual LUN(s) Physical LUN(s)
0 0
Virtual LUN(s) Physical LUN(s)
0 0
1-2 0-1
iSCSI Gateway Service Administrator's Guide
53-1000603-01