Document Feedback - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Troubleshooting Manual

2. Switch Serial Number
3. World Wide Name (WWN)

Document feedback

Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
xiv
•
Detailed description of the problem, including the switch or fabric behavior immediately
following the problem, and specific questions
•
Description of any troubleshooting steps already performed and the results
•
Serial console and Telnet session logs
•
syslog message logs
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below.:
*FT00X0054E9*
FT00X0054E9
The serial number label is located as follows:
•
Brocade 200E—On the nonport side of the chassis.
•
Brocade 4016—On the top of the switch module.
•
Brocade 4018—On the top of the blade.
•
Brocade 4020 and 4024—On the bottom of the switch module.
•
Brocade 4100, 4900, and 7500—On the switch ID pull-out tab located inside the chassis
on the port side on the left.
•
Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch
•
Brocade 300, 5100, and 5300—On the switch ID pull-out tab located on the bottom of the
port side of the switch.
•
Brocade 7600—On the bottom of the chassis.
•
Brocade 48000—Inside the chassis next to the power supply bays.
•
Brocade DCX and DCX-4S Backbone—On the bottom right on the port side of the chassis.
Use the wwn command to display the switch WWN.
If you cannot use the wwn command because the switch is inoperable, you can get the WWN
from the same place as the serial number, except for the Brocade DCX. For the Brocade DCX,
access the numbers on the WWN cards by removing the Brocade logo plate at the top of the
nonport side of the chassis.
For the Brocade 4016, 4018, 4020, 4024, and 5424 embedded switches: Provide the license
ID. Use the licenseIdShow command to display the WWN.
documentation@brocade.com
Fabric OS Troubleshooting and Diagnostics Guide
53-1001187-01