Configuring Asset Polling; Domain Id Configuration On A Phantom Switch; Configuring The Domain Id On A Phantom Switch - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

11

Domain ID configuration on a phantom switch

TABLE 17
•
•

Configuring asset polling

1. Select the amount of time between polling that Fabric Manager should wait to check for state
2. If no state changes have been received, set the amount of time that Fabric Manager should
3. Click OK.
To reset the settings to the default values based on your SAN size, click Reset.

Domain ID configuration on a phantom switch

Selecting a fabric from the metaSAN view shows the phantom switches available in the fabric,
listed as nodes. At least one switch in the fabric must be running Fabric OS v5.3.0 or later.

Configuring the domain ID on a phantom switch

1. In the metaSAN view, move to the Information panel and select the switch.
2. Right-click on the fabric containing the switch and select Configure Domain ID, as shown in
176
Asset collection triggers (Continued)
•
Switch status Port disabled
change
•
Changed related to Zone DB manipulations
Default Zone
Access mode
changes within the fabric.
wait before polling again.
FIGURE 115
Configure asset polling
Figure 116.
•
Effective Zone Cfg changed /
disabled
Fabric Manager Administrator's Guide
53-10000610-02