Compaq ProLiant 8500 Maintenance And Service Manual page 140

3-62 Compaq ProLiant 8500 Server Maintenance and Service Guide
The following ASR-2 flow chart shows you the sequence of events after a hardware or software
error occurs.
If the server continues to experience
hardware/software errors and the
number of ASR cycles exceeds the
specified number of recovery
attempts, the server logs an error to
the Server Health Log or the
Integrated Management Log and
starts the Compaq utilities from the
system partition on the hard drive.
Figure 3-1. ASR-2 flow chart
Hardware/Software error occurs.
Error is recorded in the Critical Error
Log or the Integrated Management
If a modem is installed and paging
|
Unattended server starts the
operating system.
|
|
Log, depending on the server
configuration.
|
Operating system halts normal
operation.
|
ASR timer expires.
|
Server is reset.
|
is enabled, the Server Failure
Notification pager alert is sent to
the Server Administrator.
---Or---
the Server Administrator can dial in
Server starts the Compaq utilities
from the system partition on the
hard drive.
|
If a modem is installed, ASR puts
the modem on auto-answer so that
(using third-party terminal emulator
software) to remotely run the
Compaq utilities to identify the
source of the fault.
|
Or
|
Local server administrator runs
Compaq utilities from server
console to identify the source
of the fault.