Subscribe to Our Youtube Channel
Related Manuals for Chamberlain LiftMaster TAC2C
Summary of Contents for Chamberlain LiftMaster TAC2C
- Page 1 The Chamberlain Group 845 Larch Ave. Elmhurst, IL 60126-1196 www.liftmaster.com TAC2C & TAC2D ® TAC1 RETROFIT KIT FOR CROWN JEWEL & DOORKING 1812 SYSTEMS Programming Guide...
- Page 2 PROGRAMMING » KEYPAD NOTE: Use the STAR Key “*” to cancel any input. PROGRAMMING INSTRUCTION SYNTAX KEYSTROKES General Programming Master Code + Command 1234 + 1 (12,123) Code Programming Master Code + Command + Code 1234 + 1 (12) + 1234 Relay Programming Master Code + Command + Setting 1234 + 123 + 1234...
-
Page 3: Code Setup
PROGRAMMING » KEYPAD CODE SETUP The unit’s Master Code is for owner/administrator level commands. The User Codes allow users to activate and latch relays 1 and 2. NOTE: The User Code cannot be the same as the Master Code. DELETE USER CODE NUMBERS ENTER A USER CODE NUMBERS 1. -
Page 4: Telephone Programming
PROGRAMMING » TELEPHONE TELEPHONE PROGRAMMING ENABLE INTERCOM MODE ADJUST “PICK UP” RING COUNT Enter the command tone: 1. Enter the command tone: 2. Enter the ring count: through ENABLE TELCO MODE Enter the command tone: ENABLE ALTERNATE DTMF PROGRAMMING This feature changes the fi rst programming digit from ENABLE STANDARD (LONG) RING TONE Enter the command tone: Enter the command tone:... -
Page 5: Quick Reference
PROGRAMMING » QUICK REFERENCE KEYPAD PROGRAMMING PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE Trigger Relay One Master Code (4 digits) + 1 Trigger Relay Two Master Code (4 digits) + 2 Master Code (4 digits) + 7 + User Code that is to be deleted Delete User Code (4 digits) Master Code (4 digits) + 9 + New User Code... - Page 6 PROGRAMMING » QUICK REFERENCE TELEPHONE PROGRAMMING PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE **01 Enable Call Forwarding Disabled **01 **02 Disable Call Forwarding **02 **03 Enable Intercom Mode Disabled **03 **06 Verify Call Forwarding Number (Via Caller ID) Disabled **06 **07...
- Page 7 PROGRAMMING » RESIDENT INSTRUCTIONS FOR TAC MODELS DIRECT COMMANDS FROM THE LOCAL TELEPHONE Direct commands allow you to control the unit from the resident telephone. To use direct commands lift the handset, wait for dial tone and enter the direct command. PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING...
-
Page 8: Limited Warranty
FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-2806 www.liftmaster.com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery.
Need help?
Do you have a question about the LiftMaster TAC2C and is the answer not in the manual?
Questions and answers