®
Overview
The Wireless Keypad uses a digitally secure intercom
link that allows it to control one access point. The
Wireless Keypad is compatible with various LiftMaster
Wireless Products.
Model WKP5LM3 can hold up to 5 PIN Numbers.
Model WKP250LM3 can hold up to 250 PIN Numbers.
Carton Inventory
1
2
3
4
5
6
7
8
9
*
0
#
C ncel
Keypad
Assembly
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Keypad will beep.
Keypad will continuously beep indicating no Master
PIN Number has been programmed. Proceed to Initial
Setup.
For more information, visit www.devancocanada.com or call toll free at 855-931-3334
Bolt (4)
Screw (4)
Washer (4)
Allen Wrench
Nut (4)
Models WKP5LM3 & WKP250LM3
Initial Setup
Step 1: On keypad press:
Step 2: Enter 4 digit Master PIN Number.
Example: 1234.
?
NOTE: " * " is the cancel button that will cancel any
call or key sequence.
Program Pre-Installed LiftMaster Receiver
Step 1: Pry open the front
panel of the receiver case
with a coin or a screwdriver.
Step 2: Press and release
the Learn button on the
receiver. The Indicator Light
will light for 30 seconds
indicating that receiver is in
Learn Mode.
Step 3: Within 30 seconds enter Master PIN Number
on Keypad.
Step 4: Press "1".
Erase All Control Codes
Press and hold the Learn button on the receiver until
the Indicator Light turns off indicating that the receiver
memory is clear (about 6 seconds).
1
Wireless Keypad
#
#
#
?
?
?
Indicator Light
Learn Button