Table of Contents
Advertisement
PROGRAMMING
TELEPHONE PROGRAMMING
ENABLE INTERCOM MODE
Enter the command tone:
ENABLE TELCO MODE
Enter the command tone:
ENABLE STANDARD (LONG) RING TONE
Enter the command tone:
ENABLE ALTERNATE (DUAL) RING TONE (DEFAULT)
Enter the command tone:
CALL FORWARDING
ENTER CALL FORWARDING TELEPHONE NUMBER
Enter the command tone:
#
Up to a 14 Digit Telco Number
VERIFY CALL FORWARDING NUMBER (VIA CALLER ID)
Enter the command tone:
Hang up the phone - Wait for the ring.
TELEPHONE COMMANDS
FROM LOCAL TELEPHONE
TRIGGER RELAY 1
Enter the command tone:
TRIGGER RELAY 2
Enter the command tone:
ENABLE PARTY MODE (RELAY 1)
Enter the command tone:
To disengage party mode: Enter "*9" into the local telephone.
ENABLE "DO NOT DISTURB" MODE
Enter the command tone:
DISABLE "DO NOT DISTURB" MODE
Enter the command tone:
» TELEPHONE
0
3
0
7
1
4
1
5
#
0
6
9
5
0
4
1
1
1
2
ADJUST "PICK UP" RING COUNT
1. Enter the command tone:
2. Enter the ring count:
ENABLE ALTERNATE DTMF PROGRAMMING
This feature changes the fi rst programming digit from
to
#
Enter the command tone:
DISABLE ALTERNATE DTMF PROGRAMMING
Enter the command tone:
ERASE THE CALL FORWARDING NUMBER
Enter the command tone:
NOTE: This command will also disable the call
forwarding mode.
ENABLE CALL FORWARDING
Enter the command tone:
DISABLE CALL FORWARDING
Enter the command tone:
FROM FORWARDED TELEPHONE
ACCEPT CALL FROM UNIT ON REMOTE TELEPHONE
Enter the command tone:
Extend talk time: "Talk" or press
TRIGGER RELAY 1
Enter the command tone:
TRIGGER RELAY 2
Enter the command tone:
CALL WAITING
Press "Flash" once to answer guest, Once again to return to
outside call on telco line, if
9
pressed. If
pressed, the TAC2 will automatically return to the telco line.
4
1
0
2
5
through
1
3
#
1
6
#
8
0
1
0
2
0
0
9
5
9
5
or
5
(relay 1) or
(relay 2) is
is not
Advertisement
Table of Contents
