Connecting To A Dc Supply - Pentax 203125 - PocketJet II B/W Direct Thermal Printer User Manual

Connecting to a DC Supply

To connect your PocketJet to a 12-volt vehicle DC supply, follow the
steps below.
1. Connect an appropriate power adapter cord (either with a cigarette
plug or direct wired) to the vehicle 12VDC supply as shown in Figure
3. (These items are available as options - See Chapter 8 - Ordering)
2. Connect the power cord to the PocketJet.
3. Turn on the vehicle power, then turn on the PocketJet.
FIGURE 3. Connecting the printer to DC power
The PocketJet printer works from DC sources from 11.8 to 14.4V. If
the voltage drops below 11.8, the printer will cease to function until the
battery is recharged.
Page 3