Creating A User Account; Configuring The Ip Address - D-Link DWS-3160-24TC Hardware Installation Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Hardware Installation Guide

Creating a User Account

As you will have noticed by now is that this Switch does not have a default username and password. One of the first
and most important tasks will be to create user accounts. Logging in using a predefined administrator-level username
will give the user privileged access to the Switch's management software. Also this will prevent unauthorized access
to the Switch, and record the passwords for future reference.
An example to create an administrator-level account for the Switch called 'NewUser':
DWS-3160-24PC:admin#create account admin NewUser
Command: create account admin NewUser
Enter a case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DWS-3160-24PC:admin#
1. At the CLI command prompt, enter the 'create account admin NewUser' command and press 'Enter'. This
will create a new administrator-level account called 'NewUser'.
2. The Switch will then prompt the user to enter a password. Enter the password for the administrator account
and press the 'Enter' key.
3. The Switch will again prompt the user to enter the same password again to verify it. Enter the same password
and press the 'Enter' key.
4. A "Success" response message will be displayed, by the Switch, to verify the successful creation of the new
administrator-level account.
NOTE: Passwords are case sensitive. User names and passwords can be up to 15 characters in
length.

Configuring the IP Address

Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network manager
or other TCP/IP applications. The Switch's default IP address is 10.90.90.90. You can change the Switch's default IP
address to fit into your networking address range.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be
found by entering the command "show switch" into the command line interface, as shown below.
Figure 4- 5. To create a user account
20