D-Link DWS-3160-24TC Hardware Installation Manual page 26

DWS-3160 Series Gigabit Ethernet Unified Switch Hardware Installation Guide
Set the terminal emulation software as follows:
•
Select the appropriate serial port (COM1 or
COM2).
•
Set the data rate to 115200 baud.
•
Set the data format to 8 data bits, 1 stop bit, and
no parity.
•
Set flow control to none.
•
Under Properties, select VT100 for Emulation
mode.
•
Select Terminal keys for Function, Arrow and Ctrl
keys. Make sure to use Terminal keys (not
Windows keys) are selected.
NOTE: When using HyperTerminal with the
Microsoft® Windows® 2000 operating
system, ensure that Windows 2000 Service
Pack 2 or later is installed. Windows 2000
Service Pack 2 allows use of arrow keys in
HyperTerminal's VT100 emulation. See
www.microsoft.com for information on
Windows 2000 service packs.
After correctly configuring the terminal, plug the power cable into the power receptacle on the back of the Switch. The
boot sequence will appear in the terminal.
Figure 4- 1. COM1 Properties
Figure 4- 2. Connection Properties
18