Leveling The Dishwasher; Securing The Dishwasher - Bosch SHV68E13UC - Accepts Custom Panels Integra 800 Installation Instructions Manual

Installation instructions
Hide thumbs Also See for SHV68E13UC - Accepts Custom Panels Integra 800:
Table of Contents

Advertisement

Available languages

Available languages

Avoid Tip Over Hazard
Do not use the dishwasher
until it is completely
installed. When opening the door on an uninstalled
dishwasher,
carefully
open
the
door
while
supporting
the rear of the unit. Failure to follow
this warning
can result in serious
injury.
~12mm/0.5 ''
LEVELING
THE DISHWASHER
The unit should
now be ready to slide into the cabinet
opening. To avoid scratching the floor, use floor protection and
caution when sliding the dishwasher into the cabinet. Make
sure that the hoses and cords do not bunch up behind the
unit or kink as you slide the unit back. Make certain to slide
the unit into place before raising the leg levelers.
Level the dishwasher horizontally by turning feet clockwise
to raise or counter-clockwise
to lower front of the unit.
Level the dishwasher
vertically by turning center screw to
raise or lower the back.
Figure 16
Figure 18
For Side Mount - Stone
Countertop
i
SECURING
THE DISHWASHER
1. Drive the mounting
screws through
the holes in the
mounting brackets as shown for Top or Side Mount.
2. After the unit is installed in the enclosure,
leveled and
secured, lock the two front leg levelers in place by driving
the enclosed leg leveler locking screws into each screw
boss located in front of the levelers. See Figure 18.
3. Tighten screws until they are flush with the surface of the
bosses.
02
mm/0.1"
For Top Mount - Wooden
Figure 17
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shv68e13uc 800She55p06uc/53Shv68e13uc/18Shv68p03uc/53

Table of Contents