Final Adjustments; Door Tension Adjustment; Leveling The Dishwasher - Bosch SHU 9950 Installation Instructions Manual

FINAL ADJUSTMENTS

Door Tension Adjustment

(only in SHI and SHV models)
After installation of the dishwasher, open
and close the door several times to make
sure that it does so with ease. If the door
closes too quickly or if the door falls open,
the spring tension needs to be adjusted.
To Adjust the Spring Tension
• Obtain Spring Tension Screws (2) out
of the SHI/SHV parts bag (see Figure
3).
• Insert the screws in the right and left
sides and adjust spring tension as shown
(see Figure 22).

Leveling the Dishwasher

Raising the Rear
The rear leveling leg is adjusted by turning
the center screw at the front of the
dishwasher.
Raising the Front
The front leveling legs are adjusted by
rotating the leveling legs on the front left
and right sides of the dishwasher.
• Use a screwdriver and tap the end lightly
with a hammer to turn the legs (see
Figure 23).
Note: If additional height is needed:
Shims may be added under the leveler feet.
14 - ENGLISH
Adjust screws
on right and
left sides
Figure 22
Figure 23
www.boschappliances.com
Torx T 20