Select Options; After Dishwashing - Asko D5424 Operating Instructions Manual

Dishwashing
6

Select options

To select an option, press one of the option
buttons. The field next to the button lights when
the option is activated. The available options depend
on the selected program. Once you have started the
program, the options you selected are saved for the
next time you use the same program.
High temperature
Activate this option for improved dishwashing results.
The machine then uses a higher temperature for the
main wash.
If you want to use the lower temperature, press until
the field next to the button turns off.
You can vary the temperature as shown below:
Heavy wash: 130 °F (55 °C)/ 160 °F (70 °C)
Normal wash: 130 °F (55 °C)/ 150 °F (65 °C)
Daily wash: 140 °F (60 °C)/ 150 °F (65 °C)
Quick wash: 85 °F (30 °C)/ 140 °F (60 °C)
Eco wash: 120 °F (50 °C)/ 140 °F (60 °C)
Long dry
A higher temperature in the final rinse and a longer
drying phase improves the drying result if you activate
the Long dry option. This causes a slight increase in
energy consumption.
If you want a program with Short dry, press so that
the field next to the button turns off.
7
Press Start
The display flashes three times with the
remaining time to indicate that the program has
started. Close the door properly, otherwise the
dishwasher will not start. The display indicates
if the door is open.
16
NOTE!
If the machine does not start within 2 minutes of the
last button press, the display returns to showing the
last program run.
Stopping or changing a program
If you want to change programs after starting the
dishwasher, open the door then press and hold Stop
for five seconds. Add more detergent if the lid of the
detergent dispenser has opened. Then choose a new
program, press Start, and close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically.
Add the dishes, close the door, and the dishwasher
resumes the program.
If the dishwasher is turned off using the
main power switch or due to a power
failure
If the program was not finished, the interrupted
program resumes when power is restored.
NOTE!
During drying, the program is interrupted if the power
is cut or the door is open for more than 2 minutes.
8

After dishwashing

Once the program has finished, "End" appears
on the display.
A buzzer also sounds at the end of the program. See
the section Settings, which describes how to change
this function.
Once the dishwasher has finished, it uses only
standby power. Turn off the dishwasher using the
main power switch if you want to completely cut the
power. Turn off the water supply valve after each use.
Customer Care Center
1-800-898-1879
www.askousa.com