Adding A Listed Card; Figure 3-1. Icu Window; Figure 3-2. Add Network Card Dialog Box; Table 3-1. Icu Keys - Dell OptiPlex Gs Reference And Installation Manual

Figure 3-1. ICU Window

You can maneuver through each menu and dialog box
using a mouse. If a mouse is not available, you can use
the keys shown in Table 3-1. Each menu and menu option
has an underlined character in its name. When you press
the key for that character in conjunction with the <
key, that menu or menu option is selected
.

Table 3-1. ICU Keys

Keys Action
< >< ><y> Displays the menu containing
ALT x
the underlined letter x and
performs the operation indi-
cated by the menu item
containing the underlined let-
ter y. For example, to save a
file (that is, to display the File
menu and select the
menu option), press
<
ALT
< > Moves from one control
TAB
button or list to another.
Up- and Moves up and down items in
down- a list.
arrow keys
< > Highlights an item in a list.
SPACEBAR
< > Selects the highlighted button
ENTER
or item in a list.
3-4 Dell OptiPlex Gs and Gs+ Low-Profile Systems Reference and Installation Guide
SAVE
><f> and <s>.
A
dding a Listed Card
NOTE: If you want to add a configuration file that you
received on diskette with a new expansion card, you must
copy the configuration file to the \db subdirectory on the
backup copy of the ICU diskette. You should then reboot your
system and perform the following procedure to add the expan-
sion card.
Use the following procedure to add a listed card with the
ICU:
1. Start the ICU as described in "Starting the ICU"
found earlier in this chapter.
2. From the ICU window, click the Add button or
select
ADD CARD
3. Click the name of the category of card that you
>
ALT
want to add. If you clicked the Add button in
step 2, click the OK button.
A dialog box like the one in Figure 3-2 appears list-
ing the names of all available cards of that type.

Figure 3-2. Add Network Card Dialog Box

4. Select the name of the card you want to add.
If the name of the card that you want to add is not on
the list, see "Adding an Unlisted Card" found later in
this chapter for instructions on how to add the card.
5. If you want the ICU to select the resources for the
card, click the OK button. Otherwise, skip to
step 6.
The ICU uses the default resources set by the card
manufacturer whenever possible. If the ICU cannot
find a resource that is valid for the card and available
in the system, the utility generates an error message.
See Appendix A, "ISA Configuration Utility
from the Configure menu.