Adding An Unlisted Card; Figure 3-6. Configuration Settings Dialog Box - Dell OptiPlex Gs Reference And Installation Manual

9. To change individual resource values for the cur-
rent configuration setting, select the resource
value that you want to change and click the
Options button located below the resource values
(see Figure 3-6).
For example, when you click the value under
the Options button changes to the DMA Options button.
When you click this button, a smaller dialog box appears.
By clicking the down arrow next to the current resource
value, you can display a list of the available values for the
resource.
Figure 3-6. Configuration Settings Dialog
Box
Choose the desired value and click the OK button.
The value you selected is displayed under the
resource heading in the Configuration Settings dia-
log box.
The Options button is disabled if no alternative val-
ues are available for the selected resource.
NOTE: If you change one or more resource values
using the Options button and later change the setting
in the Configuration Choice box, the changes that
you made to the resource values are overwritten by
the default values for the new configuration choice.
10. Click the OK button in the Configuration Set-
tings dialog box when you have finished selecting
resources for the function.
3-6 Dell OptiPlex Gs and Gs+ Low-Profile Systems Reference and Installation Guide
NOTE: After modifying the system configuration, you
must turn off the system and install, remove, or change
jumper settings on the ISA expansion cards to match the
settings you selected in the ICU.
,
DMA
A
dding an Unlisted Card
Unlisted cards are ISA expansion cards that do not have
configuration files stored in the ICU database.
NOTE: If you want to add a configuration file that you
received on diskette with a new expansion card, see
"Adding a Listed Card" found earlier in this chapter.
To add an unlisted card with the ICU, perform the follow-
ing steps:
1. Start the ICU as described in "Starting the ICU"
found earlier in this chapter.
2. From the ICU window, click the Add button or
select
3. Click the name of the category of card that you
want to add. If you clicked the Add button in
step 2, click the OK button.
A dialog box appears listing the names of all avail-
able cards of that type.
4. Select
cards displayed in the dialog box that appears. Then
click the OK button.
5. Click the No button when the ICU asks if you
have a configuration file for the card.
The Configure Unlisted Card dialog box appears
with blank fields.
6. Enter the name of the card that you want to add
in the
7. For each resource you want to assign to the card,
click the box beneath the name of the resource to
be assigned and then click the Add button.
For example, if you click beneath
the button changes to Add Interrupt. When you click this
button, a Specify dialog box (in this case, Specify Interrupt)
appears. Figure 3-7 shows the Configure Unlisted Card
dialog box with the Specify Interrupt dialog box opened.
from the Configure menu.
ADD CARD
from the bottom of the list of
UNLISTED CARD
field.
CARD NAME
,
INTERRUPT (IRQ)