Seagate ST1.2 - Series 8 GB Removable Hard Drive Product Manual page 49

For PC card ATA I/O in contiguous memory mode in 3.3V operation (default)
0C6H 1BH
0C8H 07H
0CAH 01H
0CCH 01H
0CEH 21H
0D0H B5H
0D2H 1EH
0D4H B6H
1EH
0D6H
For PC card ATA I/O primary mode (1F0-1F7, 3F6, 3F7) in 5V operation (default)
0D8H 1BH
0DAH 13H
0DCH C2H
0DEH 41H
ST1.2 Series Product Manual, Rev. B
CISTPL_CFTABLE_ENTRY: (16 Bit PCCard Configuration Table Entry Tuple)
TPCE_LINK = 07h bytes
TPCE_INDX :(Configuration Table Index Byte)
Config Entry Number (bit0..5) = 01 (I/O and Memory Mode)
Default (bit6) = 0
Interface (bit7) = 0 (Interface Field Exist)
TPCE_FS
Power (bit0,1) = 01 (Vcc Only)
Timing (bit2) = 0
I/O (bit3) = 0
Interrupt (bit4) = 0
Memory (bit5,6) = 00
Misc (bit7) = 0
TPCE_PD: Parameter Selection Byte
NomV (bit0) =1
MinV (bit1) = 0
MaxV (bit2) =0
PeakI (bit5) =1
TPCE_PD: Power Parameter Definition (NomV)
Exponent (bit0..2) = 5 (1V)
Mantissa (bit3..6) =6 (3.0)
Extension (bit7) =1 (Extension Exists)
TPCE_PD: Extension = 1Eh =+0.30
TPCE_PD: Power Parameter Definition (PeakI)
Exponent (bit0..2) = 6 (100mA)
Mantissa (bit3..6) = 6 (3)
Extension (bit7) =1 (Extension Exists)
TPCE_PD: Extension = 1Eh =+30
CISTPL_CFTABLE_ENTRY: (16 Bit PC Card Configuration Table Entry Tuple)
TPCE_LINK = 13h bytes
TPCE_INDX :(Configuration Table Entry Tuple)
Config Entry Number (bit0..5) = 02 (Primary I/O Mode)
Default (bit6) = 1
Interface (bit7) = 1 (Interface Field Exist)
TPCE_IF: (Interface Description Field)
Interface Type (bit0..3) = 01 (I/O and Memory)
BVDS active (bit4) = 0
WP active (bit5) = 0
READY active (bit6) = 1
MWAIT required (bit7) = 0
- -+ - ->3.3V
+
+
- - +
- ->330mA
+
- - +
43