Water Fill Adjustment; Manual Cycle Initiation - Whirlpool R-106 Training Manual

Mid-South

Water Fill Adjustment

Many of compact icemakers used today are equipped with a water fill adjustment.
Turning the fill adjustment screw changes the alignment between the cam and switch
and alters the amount of time the fill switch is energized. One full turn of the screw in
either direction changes the fill ±13 cc's (approximate).
Mid-South Mid-South

Manual Cycle Initiation

The icemaker ejection cycle is initiated by the thermostat. If, however, the icemaker
is not ejecting, it will be necessary to manually initiate an ice ejection cycle.
After removing the front cover, turn the motor shaft (small gear) ½ turn in the counter-
clockwise direction. This will rotate the cam enough to transfer the hold switch and
provide power to the motor. If the thermostat is closed at this time, the heater will
likewise be energized and the icemaker will complete the cycle.
After manual initiation, carefully feel the bottom of the mold. It should begin to heat. If
it doesn't, either the thermostat has not yet closed or the heater is open.
Water Fill Adjustment
Clockwise decreases volume
Counterclockwise increases volume
½ turn = approximately 13cc
Note: Check all possibilities that
To Start a Harvest Cycle
Use a blade screwdriver and turn
screw counterclockwise
9
Water Fill
Adjustment Screw
could cause a short or long fill
before making a fill adjustment