Chapter 4 - Data Editing; Prefix/Suffix Overview - Honeywell 4800dr - Document Camera Barcode Manual

4
Data Editing

Prefix/Suffix Overview

When a barcode is scanned, additional information is sent to the host computer along with the barcode
data. This group of barcode data and additional, user-defined data is called a "message string." The
selections in this section are used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and after scanned data. You
can specify if they should be sent with all symbologies, or only with specific symbologies. The following
illustration shows the breakdown of a message string:
Points to Keep In Mind
• It is not necessary to build a message string. The selections in this chapter are only used if you wish
to alter the default settings. Default prefix = None. Default suffix = None .
• A prefix or suffix may be added or cleared from one symbology or all symbologies.
• You can add any prefix or suffix from the
Code I.D. and AIM I.D.
• You can string together several entries for several symbologies at one time.
• Enter prefixes and suffixes in the order in which you want them to appear on the output.
• When setting up for specific symbologies, instead of All Symbologies, the symbology ID value counts
as an added prefix or suffix character.
Prefix Scanned Data
1-11 variable length
alpha numeric
characters
ASCII Conversion Chart (Code Page
Suffix
1-11
alpha numeric
characters
1252), page A-3, plus
4 - 1