Other Programming Selections; Data Format Editor Commands - Honeywell 4800dr - Document Camera Barcode Manual

value for that symbology and scan the 2 digit hex value from the
back cover of this manual.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable for this symbology.
Scan the four digit data length from the
ual. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all
lengths.)
Step 6. Editor Commands
Refer to

Data Format Editor Commands

mand you want to enter. 94 alphanumeric characters may be entered for each symbology
data format.
Step 7. Scan Save from the
entries.

Other Programming Selections

• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary format, scan 0 from
the Programming Chart
scan 1, 2, or 3, depending on the alternate format you are clearing. Scan the Terminal Type and Code
I.D. (see Supported Terminals
that you want to delete. All other formats remain unaffected.
• Save from the Programming Chart
This exits, saving any Data Format changes.
• Discard from the Programming Chart
This exits without saving any Data Format changes.
Data Format Editor Commands
Send Commands
F1 Send all characters followed by "xx" key or function code, starting from current cursor position.
Syntax = F1xx (xx stands for the hex value for an ASCII code, see
(Code Page 1252), page A-3.)
F2 Send "nn" characters followed by "xx" key or function code, starting from current cursor position.
Syntax = F2nnxx (nn stands for the numeric value (00-99) for the number of characters and xx
stands for the hex value for an ASCII code. See
1252), page A-3.)
F3 Send up to but not including "ss" character (Search and Send) starting from current cursor posi-
tion, leaving cursor pointing to "ss" character followed by "xx" key or function code. Syntax =
F3ssxx (ss and xx both stand for the hex values for ASCII codes, see
(Code Page 1252), page A-3.)
F4 Send "xx" character "nn" times (Insert) leaving cursor in current cursor position. Syntax =
F4xxnn (xx stands for the hex value for an ASCII code, see
1252), page A-3, and nn is the numeric value (00-99) for the number of times it should be sent.)
E9 Send all but the last "nn" characters, starting from the current cursor position. Syntax = E9nn
(nn is the numeric value (00-99) for the number of characters that will not be sent at the end of
the message.)
5 - 2
Programming Chart
inside the back cover of this manual. If you are clearing an alternate format,
on page 1-3), and the barcode data length for the specific data format
inside the back cover of this manual
inside the back cover of this manual
Programming Chart inside the back cover of this man-
(page 5-2). Scan the symbols that represent the com-
inside the back cover of this manual to save your
ASCII Conversion Chart (Code Page
ASCII Conversion Chart (Code Page
Programming Chart inside the
ASCII Conversion Chart
ASCII Conversion Chart