Installation Procedures - Western Digital WDBACB0010HBK - Elements Play User Manual

Installation Procedures

Important: Plug the devices directly into a wall socket. Do not plug the
devices into a power strip, surge protector, or similar power extension.
Connect the Network Devices and Computers
1. Connect the power cables to the power jacks on each device, then plug the
opposite ends into AC power outlets in separate locations (one location must be
close to your modem or router).
2. Be sure that the power switch on each device is set to the On position. The
power LED on both devices illuminates.
Location 1
3. Connect your router (with modem and other devices/computers connected) and
up to three more devices or computers to the Ethernet ports in one location.
4. Connect up to four more devices or computers in the other location.
5. Make sure the power switch on all powerline devices is set to ON.
6. See "Sharing Internet Access on the Livewire Network" on page 4 and "Sample
Livewire Home Network" on page 5 for possible configurations.
Expand the Network with Additional WD Livewire Devices
Note: WD Livewire devices can be added to an existing powerline network with one or more non-WD
devices if the devices are HomePlug Alliance AV Certified. Go to www.homeplug.org for further
information.
Connect a power cable to each device, then plug the opposite end into an AC
power outlet in the desired location. The power LED illuminates on each additional
device.
Press the Sync button on ALL devices (WD Livewire and other powerline adapters)
within 2 minutes of installation to join an existing powerline network that includes
other manufacturers' Homeplug Alliance AV certified devices.
WD LIVEWIRE POWERLINE AV NETWORK KIT
Location 2
USER MANUAL
GETTING STARTED – 8