Replacing The Secondary Hard Disk Drive - Lenovo 3285A1U User Manual

10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
11. Connect the signal and power cables to the rear of the new hard disk drive.
12. Press down on the metal latch 2 , pivot the drive cage into place, and then
Figure 21. Installing the primary hard disk drive and bracket
13. Go to "Completing the FRU replacement" on page 122.

Replacing the secondary hard disk drive

Note: Depending on your model type, your computer might come with a
secondary hard disk drive bay for installing or replacing a secondary hard disk
drive. For computer models that do not have an internal hard disk drive and use a
remote hard disk drive accessed through the SMC - Storage Array, contact your
network or storage administrator.
This section provides instructions on how to replace the secondary hard disk drive.
slide the hard disk drive cage into the chassis.
slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in the
proper position.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Chapter 8. Replacing FRUs - Tower computers
109