Lenovo 3285A1U User Manual page 72

66
Hardware Maintenance Manual
Diagnostic Error Code
020-198-XXX
PCI test aborted
020-199-XXX
PCI test failed, cause unknown
020-262-XXX
PCI system error
025-000-XXX
IDE interface Test Passed
025-00X-XXX
025-01X-XXX
IDE interface failure
025-027-XXX
IDE interface Configuration/Setup error
025-02X-XXX
025-03X-XXX
025-04X-XXX
IDE Interface failure
025-195-XXX
IDE interface Test aborted by user
025-196-XXX
IDE interface test halt, error threshold
exceeded
FRU/Action
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Flash the system and re-test. See
"Updating (flashing) BIOS from a disc"
on page 656
3. Go to "Undetermined problems" on page
80
1. Go to "Undetermined problems" on page
80
2. Flash the system and re-test. See
"Updating (flashing) BIOS from a disc"
on page 656
3. Replace component under function test
1. PCI card
2. Riser card, if installed
3. System board
No action
1. IDE signal cable
2. Check power supply voltages
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Flash the system. See "Updating
(flashing) BIOS from a disc" on page 656
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Check power supply
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file