Dell
16 Rack Information
16.1 Overview
The ReadyRails™ sliding rail system for the R910 provides tool-less support for racks with square or
unthreaded round mounting holes including all generations of Dell racks. The optional cable
management arm (CMA) can be mounted on either the left or right side of the sliding rails without
the use of tools for fast and easy deployment.
IMPORTANT NOTES:
The R910 is not compatible with any other Dell rails including previous generation rails, but it
does use the same rails as the R810 & R815.
The R910 supports sliding rails only. Static rails are not supported.
Threaded hole racks require Dell's fixed shelf or adapter brackets available from
RackSolutions.
The CMA is not supported on racks that are less than 1m in depth including Dell's 4200 & 2400
racks.
16.2 Rails
The ReadyRails sliding rails for the R910 support tool-less mounting in 19‖-wide, EIA-310-E compliant
square hole and unthreaded round hole racks and are available with or without the optional cable
management arm (CMA).
Figure 23. R910 ReadyRails Sliding Rails with Optional CMA
As noted below, the R910 rails do not support mounting in threaded hole or 2-post racks*.
Rail
Identifier
B2
Dell PowerEdge R910 Technical Guide
Rack Types Supported by the R910
Table 14.
Mounting
Rail
Interface
Type
ReadyRails™
Sliding
Rack Types Supported
4-Post
Square
Round
Thread
√
√
X
2-Post
Flush
Center
X
X
57