Table of Contents
Advertisement
4.
Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
P5B-VM SATA Connectors
•
You must install Windows
Service Pack1 before using Serial ATA hard disk drives.
•
When using the connectors in standard IDE mode, you can connect the
primary (boot) hard disk drive to any of the SATA connectors.
5.
CPU, and chassis fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN1)
The fan connectors support cooling fans of 350 mA ~ 2000 mA (24 W max.)
or a total of 1 A ~ 7 A (84 W max.) at +12V. Connect the fan cables to the fan
connectors on the motherboard, ensuring that the black wire of each cable
matches the ground pin of the connector.
P5B-VM Fan Connectors
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors!
ASUS Pundit P3-PH5X
SATA1
SATA2
2000 Service Pack 4 or the Windows
®
CHA_FAN 1
GND
+12V
Rotation
CPU_FAN
XP
®
4-7
Advertisement
Table of Contents
