Part 2: Installing And Configuring A Modem - HP 234664-002 - ProLiant - ML330T02 Installation Instructions Manual

Perform the SNMP configuration steps below to enable support for the HP Insight Management
9.
Agents:
– Select the Install SNMP check box.
– Enter the community strings and IP address information into the appropriate window boxes.
– Click the Continue button.
NOTE:
For the HP Insight Management Agents to function properly, SNMP
installation and configuration is required before installing the PSP.
The SNMP Service default security is set to no community string
and no community rights. With these settings, the Insight
Management Agents Version 6.1 (or earlier) will be unable to
display the Version Control inventory on the Version Control
Agents Home Page. SNMP is not installed by default.
CAUTION:
A potential security risk exists due to SNMP messages being sent in
clear text. These clear text messages are easily intercepted and
decoded by network analyzers, such as Microsoft Network
Monitor. Community names can be captured and used by
unauthorized personnel to gain valuable information about
network resources.
After receiving a warning that the drives will be erased, click the Continue button. At this point, the
10.
drivers and the PSP will be installed.
Upon the automatic ejection of the SmartStart CD and the prompting to insert the OS CD, insert
11.
the Windows SBS 2003 R2 Disk 1, and click the Continue button. Once the OS data files are
copied, the OS CD will be ejected and the server will be rebooted automatically. This step marks
the beginning of the OS installation.
Follow the on-screen instructions to complete the OS installation.
12.

Part 2: Installing and configuring a modem

Windows SBS 2003 R2 may not contain the correct drivers for the server's modem. If a modem is
installed after Windows SBS 2003 R2 installation completes, the Hardware Wizard runs
automatically.
When the Welcome to the Found New Hardware Wizard window displays, click Next.
1.
In the Install Hardware Device Drivers window, search for a suitable driver for the device, and
2.
click Next.
Select from the Optional search locations on the Locate Driver Files window. Provide the OEM
3.
driver if it is located on a diskette, and click Next. After the wizard completes the search, it
displays the driver it found for the modem.
Click Next to install the found driver.
4.
Click Finish to complete the Found New Hardware Wizard. The modem should now be functional
5.
with Windows SBS 2003 R2.
6