Route Guidance Calculation - Sony MEX-100NV Operation Manual

7890_GB.book Seite 92 Montag, 1. Juli 2002 1:20 13
Navigation operation
For final storage in the destination memory, either route guid-
ance must be started or the program must be switched to new
destination entry by selection of
Deleting stored destinations
Select destination memory (see page 104).
Select the destination to be deleted using the SELECT control
and press the multifunction button.
Destination memory full
Occurs when the destination memory is full.
Select either (to jump to the destination memory in
order to delete a destination) or
92

Route guidance calculation

.
The message "Calculating route" indicates that the distance is
being calculated, which may take several seconds.
After the first route guidance announcement, the prompt
flashes on the display until the route has been completely cal-
culated. When entering a destination, driving off should be
delayed until
Recalculating the route.
If the current route is not followed due to road blocks, diver-
sions, unintentional driving in the wrong direction or failing
to observe the recommendations, the system immediately cal-
culates a new route. During this recalculation,
displayed.
(to cancel saving).
+ ,
no longer flashes.
is