Using Smartmedia; Using The Floppy Disk Adapter (Flashpath) - Sharp VN-EZ1U Owner's Manual

USING SMARTMEDIA

USING SMARTMEDIA
With PixLab, movies and still images stored on a SmartMedia card can
easily be copied to and viewed on your computer. Below is a description
of how to load the SmartMedia card onto the computer.
The explanations in this manual presume that you are using the
VN-EZ1.
For instructions on loading models not described here, refer to the
respective model's operating instructions.
A driver for the floppy disk adapter for your computer must be pre-
installed.
For details, refer to your floppy disk adapter's operating instruc-
tions.

Using the Floppy Disk Adapter (FlashPath)

1
Remove the SmartMedia card from the VN-EZ1.
When doing so, be careful not
to drop the battery.
2
Load the SmartMedia card with
its contact surface facing the
opposite side of the FlashPath's
metal surface.
Check that the SmartMedia card
is in the direction indicated on the
diagram on the adapter, then in-
sert it fully to the rear.
notice The SmartMedia card will not operate if it is not completely inserted.
The SmartMedia card will not operate if it is inserted upside-down.
Use a 3.3V SmartMedia.
3
Load the floppy disk adapter
into the computer's floppy disk
drive.
5