Gps Simulator; To Get To The Gps Simulator - Eagle IntelliMap 500C Installation And Operation Instructions Manual

GPS Simulator

The GPS simulator lets you use the unit as if you were outdoors navigat-
ing somewhere. It's a great way to practice using your unit. You can set
the starting location by entering latitude/longitude (Starting Position) or
from a stored waypoint, map place or POI location (
mand). You can steer your position and change speed on the map by us-
ing the arrow keys (
and speed in the dialog boxes provided on the simulator menu screen.

To get to the GPS Simulator:

1. Press
MENU
2. Press ↓ to
GPS S
GPS Setup Menu, left; GPS Simulator menu, center. Map Page shows
Track and Speed steering arrow indicators, right. In this example, you
are "traveling" across Mudisland Point on a track of 19º
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to erase this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER
| |
EXIT EXIT EXIT
S
TEER WITH
| |↓ to
MENU GPS S
|
IMULATOR
at a speed of 50 miles per hour.
box and pressing
O
N
A
WITH RROWS
to return to the previous page.
command) or by setting the track
A
RROWS
|
ENT
ETUP
. The GPS Simulator Menu appears.
ENT
ENT
EXIT
command, press
77
C
HOOSE
.
key. Press
to clear the steering and
ENT
com-
S
TART
| |
EXIT EXIT EXIT
, then Press