Eagle Strata 128 Portable Install And Operation Instructions page 17

Clean the chosen area of the hull before attaching the suction cup. Locate
the transducer on the hull as shown below. Don't allow the bracket to go
below the hull, as water pressure against it can cause the suction cup to
come off at speed. Moisten the cup, then press it onto the hull as firmly as
possible. Tie the nylon cord to the boat and route the transducer cable to
the sonar unit. Plug the transducer connector into the unit and your
portable sonar is now ready for use.
SPEED/TEMPERATURE SENSORS
The Strata Plus and StrataView can use up to three temperature sensors
which can monitor surface water, live well, air, and virtually any other
temperature. You do need to be careful when purchasing the temperature
sensors, however. Each temperature sensor has its own "address". The
sensors are labeled "Water", "T-2" (or Temp-2), and "T-3" (or Temp-3). If
you want two (or more) temperature readings, you'll need to use the proper
sensors. For example, you can't use two T-3 sensors. The sensors that will
fit these units are:
TS-1BK
TS-2BK
TS-3BK
TS-12BK
ST-TBK
You can combine these sensors in many combinations. See the list on the
following page for temperature and speed sensor combinations.
HULL
One sensor for "Water" temperature display.
One sensor for "T-2" temperature display.
One sensor for "T-3" temperature display.
Two sensors for "Water" and "T-2" temperature displays.
One speed sensor and one temperature sensor for
"Speed" and "Water" displays. (comes with Strata Plus)
17