Installing The Appliance; Gas Connection - Samsung GN642FFXD Installation And User Manual

Installing the appliance

1. Place the bracket(B) over the holes that match the size
of the screws.There are one set of screw holes in each
(A) SEALING STRIP
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position it.
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
(C) SCREW (B) BRACKET
Then fully tighten the screws(C) to secure the hob into
position.
H H
H H
1. Remove the pan support, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2. Apply the sealing strip provided around the
edge of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
21

Gas Connection

■ This appliance must be installed and connected in accordance with installa-
tion regulations in force in the country in which the appliance is to be used.
■ This appliance is supplied to run on natural gas only and cannot be used on
any other type of gas without modification.
Conversion for use on LPG and other gases must only be undertaken by a
qualified person.
The gas inlet connection fitting is 1/2 inch female thread.
Gas distributed by pipe ; natural gas, propane-air gas or butane-air gas
For your safety, you must choose from the three following connection option.
■ Connection with a rigid pipe made from copper and with
screw-on mechanical connectors.
Make the connection directly to the end of the elbow fitted on
the appliance.
■ Connection using flexible undulated metal tube with
Elbow
screw-on connectors. (Fig. A)
You can use a flexible stainless steel pipe available from your
after sales service department.
■ Connection using flexible tube with screw-on connectors.
(Fig.B)
These tubes must not exceed 2 meters in length and must be
Fig.A Fig.B
accessible along their entire length.
Gas supplied by tank or cylinder (butane/propane)
■ For the user's safety, we advise the connection to be made
with a rigid pipe if this is possible, using a flexible undulated
metal tube with scerw-on connectors (maximum length
2meters) (Fig.A)
■ For an existing installation, where it is not possible to fit a
Elbow
reinforced, braided, flexible gas hose, the connection can be
Gasket
made with a flexible gas hose (maximum length 2meters),
Connector
with two clamps.
One on the connector, and the other on the pressure
Clamp
regulator, and a gasket should be fitted between the
connector and the hob's elbow. (Fig.B)
Fig.A Fig.B
■ You can obtain the connector and the gasket from your After-Sales Service.
In France, you must use a tube or a pipe featuring the "NF Gaz" logo.
If the installation is difficult, unscrew the Elbow slightly and tighten it after
locating the Elbow.
■ A full operational test and a test for possible leakages must be carried out
by the fitter after installation. (such as soap water or gas detector)
■ Access to the whole length of the connection hose must be possible and
the gas hose must be replaced before its use before the end of service life
(indicated on the hose)
22