Positioning; Installing The Appliance - Samsung GN641FDXD1 Installation And User Manual

Positioning

CLEARANCES REQUIRED CLEARANCES REQUIRED
WHEN FITTING THE HOB WHEN FITTING THE HOB
WITHOUT A COOKER HOOD ABOVE WITH A COOKER HOOD ABOVE
700 mm
700 mm
400 mm
400 mm
FO 0812 FO 0813
■ This appliance is to be built into a kitchen unit or 600mm worktop, providing the
following minimum distances are allowed ;
- The edge of the appliance must be a minimum distance of 55mm from a rear wall.
- A minimum distance of 100mm must be left between the side edges of the appliance and any
adjacent cabinets or walls.
- The minimum distance combustible material can be fitted above the appliance in line with the
edges of the appliance is 400mm. If it is fitted below 400mm a space of 50mm must be allowed
from the edges of the appliance.
- The minimum distance combustible material can be fitted directly above the appliance is 700mm.
a
- This panel(a) must be positioned at a maximum distance of 150mm below the worktop.
600 mm
400 mm
Cut out size
400 mm
Width : 560mm
Depth : 480mm
Thickness : 30~50mm
40mm
150mm (MAX)
22

Installing the Appliance

Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
1. Place the bracket(B) over the holes that match the size
of the screws.There are one set of screw holes in each
(A) SEALING STRIP
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position it.
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
(B) BRACKET
(C) SCREW
position.
H H H
H
H H
1. Remove the pan support, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2. Apply the sealing strip provided around the
edge of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
H
H
23