Installing The Appliance - Samsung NA64H3000AK User & Installation Manual

Installing the appliance

(Stainless steel model)
(B)
Sponge
(A)
The thickness of the sponge in stainless model is 1.5mm
The thickness of the sponge in glass model is 3.0mm
(A)The width of the sponge is 10mm
(B)The width of the sponge is 20mm
(A) SEALING STRIP
(C) SCREW
H
H
23 _Installation Of Appliance
(Glass model)
(A)
(B)
Bottom view
. 2
. 3
(B) BRACKET
H
H
appliance upside down and place it on a
cushioned mat.
supervision devices are not damaged in this
operation.
2. Apply the sponge provided around the
edge of the appliance.
. 3 D o n t o e l a
overlap the thickness.
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
C a e r u f y l l u t n r h t e h
into the aperture hole that you have cut out.
O n h t e u n d e n r e a h t
position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
position.
v e a g a p n i h t e s e a
o b b a k c o v r e a n d h t
f o h t e h o , b a d u j t s h t
n i l g a g e t n r o
e n g e n y l t o l w r e t i
e b a r k c e s t n i o t a