Advertisement
Buffer full recovery timing
When the available space for bytes in the print buffer
drops to 512 or 16 bytes, data entry is disabled. As the
printer prints the data in the buffer, the vacant area for
bytes increases. when this vacant area reaches one of
cation is resumed. These settings are selectable by using
the DIP switches.
The jumper is a small terminal used for connecting or
disconnecting a circuit. The jumper is on when the
jumper plug covers
settings can be changed by either attaching or removing
the rectangular jumper plug. If the jumper is to be
turned off, connect it to just one of the two terminal pins
as shown in the figure below. By doing this, you can
avoid losing the unused jumper plug.
both wires of the terminal. Jumper
10
Advertisement
