Advertisement
If the host computer is not equipped with a power
1.
supply for the Current loop interface, these
jumpers must be connected to perform communica-
tion via the Current loop interface
2
Either J8 or j9 jumper is connected at the factory,
and you should not change this setting
3.
Either JCX or JCF jumper must be connected.
Either JCL or JRS jumper must be connected.
4.
Jumper settings for RS-232C and current loop
Refer to the table below for information on the four
available handshaking protocol selections.
Table 7. Protocol selection in RS-232C mode
Protocol selection in Current Loop mode
Table 8.
I
JCL
12
OFF
Advertisement
