Oven Ceiling - Electrolux EOD3410AOK User Manual

20 www.electrolux.com

OVEN CEILING

You can fold down the heating element on
the oven ceiling to clean the oven ceiling
easily.
Folding down the heating element
1. Remove the shelf support rails.
2.
Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring pres-
sure and out along the support on
both sides.
Removing the door and the glass panels
B
A
A
4.
The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite
sequence.
Install the heating element correctly
on the two sides above the support
on the inner wall of the oven.
2. Insert shelf support rails.
OVEN DOOR AND GLASS
PANELS
You can remove the oven door and the in-
ternal glass panels to clean them. The
number of glass panels is different for dif-
ferent models.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy.
1. Open the oven door as far as it goes.
2.
Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first posi-
tion (angle approx. 45°).
4. Hold the oven door with one hand on
each side and pull it away from the
oven at an up angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6.
Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
7. Pull the door trim to the front to re-
move it.