Connecting To A Power Source - Canon DZ-3600U User Manual

Connecting to a Power Source

Connect the DZ-3600U to a power source with the supplied power cord.
16
This explanation assumes that you have already removed the main unit
and accessories from the box and placed them on a stable surface. If you
have not yet unpacked them, read and follow the steps described in
Removing the Equipment from the Box (P.106), then find a suitable
location.
!!! Important !!!
• Do not use a power cord other than the one supplied. Plug it into a 120-
volt electrical outlet only. Use with other voltages may result in fire,
electric shock or other hazards.
• Ensure that the power switch on the main unit is set to Off before you
plug in the power cord.
Rear Panel of the Main Unit
VIDEO S VIDEO VIDEO S VIDEO
EXT
OUTPUT
IN 1
EXT
IN 2
Power Cord (supplied)
1.
Insert the female end of
the power cord (the end
with 3 holes) into the AC
Inlet on the main unit's
rear panel.
RS-232C
AC INLET
USB
60/100
HandShake
Reserved
Service Mode
OFF ON
2.
Plug the other end of the
power cord into an electrical
outlet.