General; Specifications; Legal Notices - Dynex DX-LCD32-09 User Manual

20

General

Problem
One or more channels
cannot be displayed.
Password lost.
Some menu options cannot
be accessed.
TV cabinet creaks or makes
noises.
Control buttons on the TV
do not work.

Specifications

Product design and specifications are subject to change without notice.
LCD TV
Type
32" TFT LCD
Panel
NTSC-M, ATSC
TV system
VHF: 2-13
Receiving channels
UHF: 14-69
CATV: 1-125
CADTV: 1-135
DTV: 2-69
BTSC system
Audio multiplex
6 W × 2
Audio out
AC 120 V, 60 Hz
Power requirement
150 W
Power consumption
31.9 × 23 × 10 inches
Dimensions
(81.1 × 58.3 × 25.5 cm)
(W × H × D)
30.9 lbs (14 kg)
Weight
Storage: 32° to 122°F (0° to 50°C)
Temperature
Working: 41° to 104°F (5° to 40°C)
Composite video/audio (L/R) (1)
Input ports
S-Video (1)
Component video/audio (L/R) (2)
HDMI (2)
VGA/audio (1)
Antenna (1)
Composite video/audio (L/R) (1)
Output ports
Headphone (1)
S/PDIF (optical) (1)
RS-232
Control port
Solution
• Make sure that your TV has
memorized channels.
• Make sure that the channel has
not been deleted from the
memorized channel list. If the
channel was deleted, you can
press the number buttons on the
remote control to tune to the
channel.
• Make sure that the channel is not
blocked through the parental
controls.
• If you have forgotten the
password, enter 1397 to open the
Lock menu and set a new
password.
• If an option is grayed, the option
is not available for the current
video input mode.
• This is not a malfunction. When
you use your TV, the temperature
inside the cabinet increases. This
causes the cabinet to expand or
contract, which makes a creaking
noise.
• Unplug the power cord, wait a
few seconds, plug the cord back
in again, then turn on your TV.

Legal notices

FCC Part 15
This equipment has been tested and found to comply within the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party
responsible for compliance with the FCC Rules could void the user' s
authority to operate this equipment.
FCC warning
This is a CLASS B product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures to counter interference.
Notices
Specifications and features are subject to change without notice or
obligation.
For service and support call (800) 305-2204.
Specifications