Asus P9X79 LE User Manual page 41

2. Intel X79 Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_3–6 [blue])
®
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical disc
drives via Serial ATA 3.0 Gb/s signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10
configuration with the Intel
chipset.
• These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID
Mode]. Refer to section 3.5.4 SATA Configuration for details.
Before creating a RAID set, refer to section 4.4 RAID configurations or the manual
•
bundled in the motherboard support DVD.
When using NCQ, set the SATA Mode in the BIOS to [AHCI Mode]. Refer to section
•
3.5.4 SATA Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
IRST driver note for OS installation
Windows XP:
•
32 bit: Intel IRST driver for X79 platform will NOT support Windows XP 32 bit. Please
set to [IDE Mode] for OS installation.
64 bit: When [SATA Mode] is set to [AHCI Mode][RAID Mode], it is necessary to load
IRST Driver from driver disk during OS Windows XP 64 bit installation for the system
to detect the storage devices. For details, please refer to the section "4.5 Create a
RAID driver disk".
Windows 7 & Vista:
•
When [SATA Mode] is set to [RAID Mode], you must load IRST Driver during Windows
7 or Vista installation for the system to detect the Optical Disk Drive (the ODD should
be connected to the Intel SATA ports), or else the ODD will not run. We strongly
recommend you save the IRST Driver from SCD to the USB Flash Drive before OS
installation.
ASUS P9X79 LE
® Rapid Storage Technology through the onboard Intel
® XP Service Pack 3 or later versions before using Serial
XP SP3 or later versions.
®
® X79
2-23