Table of Contents
Advertisement
Installation instructions
2. Remove the two screws indicated on the back
of the washing machine.
3. Secure the anti-tip device using the screws as
shown in the picture.
4. Attach the plastic cups for mounting the tumble
dryer's front feet to the washing machine's top
cover. This is essential, as only when the
tumble dryer's feet are resting in the plastic
cups can you be sure that the dryer is correctly
positioned on the washing machine.
Break off tab A on the cup fitted on the right
side and tab B on the cup fitted on the left side.
Then remove the paper from the self-adhesive
surface under the plastic cups.
A
A
B
B
5. Fit the plastic cups so that the "tags" marked
with arrows are against the front edge or side
edge of the cover and press them firmly onto
the cover. Then break off the remaining tabs.
6. Push out the knock-out hole on the back of the
dryer (you don't have to completely remove
the knockout, just fold it up far enough for the
stacking bracket to fit inside the slot) using a
hammer and screwdriver.
7. Push the tumble dryer in under the metal
brackets. At the same time, keep the front edge
raised by 0,4" (10 mm) to 0,8" (20 mm).
8. Lower the tumble dryer's front feet into the
plastic cups and adjust the dryer to ensure that
it is balanced.
Adjusting the feet
Screw the feet in or out so that the tumble dryer
is steady and balanced on the floor or on the
washing machine if stacking. Then tighten the
lock nuts.
Customer Care Center
1-800-898-1879
www.askousa.com
Lock nut
21
Advertisement
Table of Contents
