HP 316095-B21 - StorageWorks Edge Switch 2/24 Release Note page 20

About this document
Workaround
This is corrected by restoring the LAN connection and rebooting the appliance.
Rebooting the appliance has no impact on the Fibre Channel operations of any
switch or director. Only monitoring switch operations, logging events, and
implementing configuration changes are interrupted.
Setting HAFM appliance LAN to use DHCP is activated to wrong LAN
When setting the IP configuration for the HAFM appliance using the LCD panel,
setting DHCP configuration for LAN 1 causes LAN 2, not LAN 1, to be
configured for DHCP. Similarly, setting DHCP configuration for LAN 2 causes
LAN 1, not LAN 2, to be configured for DHCP.
Workaround
If you wish to configure LAN 1 for DHCP, select LAN 2 instead of LAN 1 at the
start of the configuration procedure. If you wish to configure LAN 2 for DHCP,
select LAN 1 instead of LAN 2 at the start of the configuration procedure.
Event notification by e-mail cannot be disabled for individual switches
If you enable Event Notification by e-mail, all switches are enabled for event
notification by e-mail, and cannot be individually disabled from sending e-mail
notifications, even if the Enable E-mail Notification check box in the switch
Element Manager's Maintenance menu is unchecked. The only way to disable
e-mail notification is to disable Event Notification for HAFM for all switches (at
HAFM main window, select Monitor > Event Notification > Email, and
uncheck the box for Enable Email Event Notification).
Event notification by e-mail or call home can be missing information under certain
conditions
Though very unlikely, it is possible that an Event Notification by e-mail or call
home may be missing information normally contained in these messages. This
occurs if a switch detects an event that requires a notification to be issued, but
HAFM has not completed discovery of the switch. This discovery of a switch is
usually completed within a few seconds, so it is unlikely, though not impossible,
that an event occurs during this short span of time. Discovery of a switch occurs
when it is added to HAFM for management, and when the Ethernet connection to
a switch is broken and re-established, such as when a switch's firmware is
upgraded.
20 HP StorageWorks HA-Fabric Manager release notes