Destination Settings - Canon iP4000 - PIXMA Photo Printer Service Manual

(6) Service mode
Function
Service test print
- Model name
- ROM version
- USB serial number
- Waste ink amount
- CD-R sensor correction
EEPROM initialization
Waste ink counter reset

Destination settings

Note: At the end of the service mode, press the Power button. To protect the media sensor from being dislocated during transportation, the paper lifting plate of
the sheet feeder unit will be raised.
<Service mode operation procedures>
1) With the printer power turned off, while pressing the Resume/Cancel button, press and hold the Power button. (DO NOT release the buttons. The LED lights in
green to indicate that a function is selectable.)
2) While holding the Power button, release the Resume/Cancel button. (DO NOT release the Power button.)
3) While holding the Power button, press the Resume/Cancel button 2 times, and then release both the Power and Resume/Cancel buttons. (Each time the
Resume/Cancel button is pressed, the LED lights alternately in orange and green, starting with orange.)
4) When the LED lights in green, press the Resume/Cancel button the specified number of time(s) according to the function listed in the table below. (Each time
the Resume/Cancel button is pressed, the LED lights alternately in orange and green, starting with orange.)
Time(s)
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times or more
5) After the function (menu) is selected, press the Power button. The LED lights in green, and the selected function is performed. (When the operation completes,
the printer returns to the menu selection mode automatically.)
Procedures
See "Service mode operation procedures" below.
See "Service mode operation procedures" below.
See "Service mode operation procedures" below.
See "Service mode operation procedures" below.
LED Function
Green
Power off
Orange
Service test print
Green
EEPROM information print
Orange
EEPROM initialization
Green
Waste ink counter resetting
Orange
Destination settings
Green
Print head deep cleaning
Green
CD-R test print
Orange CD-R print position correction
(horizontal)
Green CD-R print position correction
(vertical)
Return to the menu selection
Set a sheet of A4- , letter-, or larger-sized paper.
For print sample, see
test print, <Service test print sample>.
The following items are NOT initialized:
- USB serial number
- Destination settings
- Waste ink counter
- CD-R correction value
If the waste ink amount is 7% or more, replace the bottom
case unit, or the ink absorbers.
Other than Japan: iP4000
Japan: iP4100
When the print head is not installed, the carriage returns and locks
in the home position.
See 3-4. Verification Items, (1) Service test print.
See 3-4. Verification Items, (2) EEPROM information print.
Proceed to the step 5), and follow the Destination settings
procedures.
Not used in servicing.
Not used in servicing.
Not used in servicing.
1 - 15
Remarks
3-4. Verification Items, (1) Service
Remarks