Advertisement
Attaching to a car window
Car window mount
360°
Flexible arm
swivel
head
Adjustment
knob
Suction lever
Suction
cup
Suction release
button
1 Clean the window with a clean cloth.
2 Insert the swivel head into the swivel
head slot on the back of the holder and
slide it into place until it is secure.
3 Remove the clear fi lm from the suction
cup.
4 Push the release button on the
car window mount, press the suction
cup to the desired location on the
clean window, then press the suction
lever down.
The mount adheres to the window.
5 Loosen the adjustment knob, adjust
the viewing angle, then fully tighten
the knob.
Caution: Always loosen the adjustment
knob before changing the viewing
angle.
6 Bend the fl exible arm to further adjust
the viewing angle.
7 To remove the mount, press the suction
release button, then pull the suction
cup tab.
Removing your device from
the holder
1 Hold your device and repeatedly press
the release button on the bottom of
the holder. The clamps open.
2 Remove your device.
One-year limited warranty
For complete warranty, visit www.dynexproducts.com.
Contact Dynex:
For customer service call 1-800-305-2204
www.dynexproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfi eld, MN 55423-3645 USA
© 2011 BBY Solutions, Inc. All Rights Reserved. DYNEX is a trademark of BBY Solutions,
Inc. Registered in some countries. All other products and brand names are trademarks of
their respective owners.
ENGLISH 11-0296
Advertisement
